In this article, we connect an KY-011 Dual Color LED to a Raspberry Pi Pico, any Rp2040 type board will be suitable. We actually tested this with a Cytron Maker Pi Pico The KY-011 Dual Color LED module can emit red and green light. You…
This is an RP2040:bit Board Based On Raspberry Pi Microcontroller RP2040 but is the same size and pinout as the BBC Micro:bit Features On-board W25Q16 16M flash Memory chip On-board 5×5 LED matrix, each LED can be programmed separately. On-board two programmable buttons. You get…
In this example we use LEDs connected to the following pins – 16,17,18,19,20,21,22,26,27,28 to create the knight rider effect I tested this with cytron maker pi pico as it has LEDs connected to all the outputs Schematic If you want to build its fairly simple,…
The RP2040 PiZero development board is a board in the ever popular Raspberry PI Zero form factor, but at its heart is the RP2040 SoC from Raspberry PI. We get the same dual-core Arm Cortex M0+ CPU running at 133 MHz and 264KB of SRAM.…
The Seeed Studio XIAO RP2040 is a mini development board based on the Dual-core RP2040 processor. The Seeed Studio XIAO RP2040 also has 264KB of SRAM, and 2MB of on-board Flash memory which can provide more program to save and run. On the other hand,…
In this article we look at one of the RP2040 board offerings from Adafruit. In this case its a much smaller sized board called the Adafruit QT Py RP2040 The QT Py RP2040 adds an extra analog pin compared to the Pico which brings the…
In this article we look at another RP2040 board called the SparkFun Pro Micro, this is a low cost basic RP2040 board with minimal features There are two LEDs on the Pro Micro RP2040. The red LED indicates power and the other is an addressable…
In this article we look at the RGB led which is fitted on the Arduino Nano RP2040 Connect The RGB LED (DL3) is a common anode LED that is connected to the Nina W102 module. The LED is off when the digital state is HIGH…
If you are looking for a small but still extremely useful Rp2040 based board then you may want to take a look at the Tiny 2040 a board which is under half the size of the Raspberry Pi Pico The board can be directly soldered…
The Maker Pi RP2040 board is aimed at robotics with features such as a 2-channel DC motor driver, 4 servo motor ports, 7 Grove I/O connectors, and lots of LEDs connected to the I/O pins which can be used for troubleshooting. The DC motor driver…
This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Read More